Hello. I want to replace a nipple on a muzzleloader. I have new nipples that measure OD of the thread.225 and 24 thread count. I am having trouble finding a chart that shows anything close to .225X24. So I'm asking for advice. The nipples were made by CVA if this is helpful information. Thanks in advance.

I searched the part number of the nipples and it says it is a 6x1 thread. Would this be the correct tap to buy? https://www.amazon.com/1-0mm-Metric-Taper-Plug-Taps/dp/B008702N5K

Thanks again.

Last edited by liverwort; 09/12/22 03:51 PM. Reason: more info