Another question, this regarding the loader--a MEC 8567 Grabber. I tried getting the 3 crimping stations adjusted to handle the 2 1/2" RST's. I must have spent 2 hours fiddling with them (probably the first time I have needed to do that on any of the MEC loaders I use for the other gauges). I can say I didn't do very well. I think I have it back to where it was before but not even too sure about that.
I have done roll crimps by taking them out of the assembly line before they get to the crimping stations but am trying to avoid that. (Rolling them by hand and that worked fine.) So I am wondering if there is a better way to adjust the loader(using the crimping stations) to handle the shorter hulls and not doing the roll crimps. Thanks for the input! Gil
Last edited by gil russell; 03/23/22 10:26 AM.
