Thanks, Keith and Kutter. Good advice, appreciated and much to ponder. Here is what I am thinking at this time. Working with both epoxy and pre-glue veneer in practice mode I am leaning toward the high heat pre-glue. Why? In my trial pieces I find that heating the glue to 300 degrees results in the veneer becoming quite pliable and attaching quickly. With epoxy I experienced difficulty in getting the veneer piece to set in place without shifting. Most likely my lack of experience showing here. If the pre-glue does not work out I can use heat to remove the veneer and go to the epoxy. I have cut the pieces to minimize the number of seams. I also intend to seal these seams with thinned epoxy to prevent these from opening through handling.
