Origin of the DST's, Lynn?
When you disassemble the sight for finishing would it be possible to see how you designed the cam/spring arrangement for the pivoting post? Thanks.
Gary, here is a picture of the set triggers all inlet into the rifle bottom metal and cross pinned.
And a picture of the peep sight internal mechanism that allows the swing arm to move out of the way of the bolt handle and return to battery position. Its just a camming action, however the way I do it to cut the diameter of the cam surface a little bit smaller then the shaft diameter. This means you can spin the swing arm around 360 degrees and out of the way if desired without any other retaining feature to keep it held in place. I think Lyman used an additional pin or screw to accomplish the retaining of the swing arm. I can't actual swear to that as I have actually never seen or examined a Lyman 36 other then in pictures
