Pictures or it didn't happen.. i know.
[img]
http://s1289.photobucket.com/user/Demonw...?sort=3&o=1[/img]
Not finished with it yet obviously, the retaining screws of the old locks were fully rusted in and had to be dug out so i'll have to let two lumps in at the rear of the locks to inlet around them properly, then they will be hidden by the checker, the small gaps around the locks will be taken up with fillet's of wood dovetailed in when i get around to it. The have to fit pinfire hammers to it, as the locks are hammer gun locks.
But finding old locks to replace the missing locks on yours will be difficult but not impossible. You could soon have it functional again. If the gun really warrented the expense and time, i would have just milled out the original inlet and inlet an entire block of wood into the gap and fit locks from scratch.
