|
S |
M |
T |
W |
T |
F |
S |
|
1
|
2
|
3
|
4
|
5
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
29
|
30
|
|
|
|
|
|
Forums10
Topics38,466
Posts545,106
Members14,409
|
Most Online1,258 Mar 29th, 2024
|
|
|
Joined: Feb 2003
Posts: 1,624 Likes: 13
Sidelock
|
OP
Sidelock
Joined: Feb 2003
Posts: 1,624 Likes: 13 |
Rebluing a very nice 1932 Heym double. Have the barrels almost prepped and went to remove the stop screw for the extractor. It's been in there for 90 years and seen some inclement weather based on the condition of rest of the gun. Of course the slot stripped out. Now trying to set it up in the drill press and the center drill is too short to reach the screw (because the bottom lug on the barrels is in the way of the drill press chuck). I may have to use a center punch and regular drill and forget the center drill. Any ideas? Thanks.
[IMG]
|
|
|
|
Joined: Dec 2001
Posts: 6,993 Likes: 402
Sidelock
|
Sidelock
Joined: Dec 2001
Posts: 6,993 Likes: 402 |
Center drills are available in a multitude of lengths, order up a long or extra long one and proceed as normal.
|
|
|
|
Joined: Jan 2013
Posts: 1,124 Likes: 195
Sidelock
|
Sidelock
Joined: Jan 2013
Posts: 1,124 Likes: 195 |
For small screws I gave up trying to use a center punch and standard drill because one or other would wander, I replaced the drill for a carbide end mill that is far easier to center on the damaged screw.
The only lessons in my life I truly did learn from where the ones I paid for!
|
|
|
|
Joined: Feb 2003
Posts: 1,624 Likes: 13
Sidelock
|
OP
Sidelock
Joined: Feb 2003
Posts: 1,624 Likes: 13 |
Thanks so much for the replies. I think I got lucky; I didn't have access to a longer center drill and didn't want to wait days or longer to get one. I was able to get an abrasive sphere into the slot after some work with a small file. That helped me figure out where the center of the hole/screw needed to be. And then I SLOWLY drilled it out using progressively larger drills. So I have it set up for a #4-40 (#48 drill). I think the original one may have been a bit larger (obviously metric) and I may end up using a #5. Thanks again for the help. Gil
[IMG]
|
|
|
|
|
|