March
S M T W T F S
1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31
Who's Online Now
5 members (Marc Ret, SKB, Argo44, FlyChamps, 1 invisible), 370 guests, and 2 robots.
Key: Admin, Global Mod, Mod
Forum Statistics
Forums10
Topics38,374
Posts544,002
Members14,391
Most Online1,131
Jan 21st, 2024
Previous Thread
Next Thread
Print Thread
Page 1 of 2 1 2
Joined: Nov 2014
Posts: 125
Likes: 3
bls Offline OP
Sidelock
**
OP Offline
Sidelock
**

Joined: Nov 2014
Posts: 125
Likes: 3
I have found a nice Ferlach Drilling in my local shop, and I've always wanted one if nothing else to try out and see what it is about, BUT, my main hang up on acquiring this nice gun is:
What the heck do I hunt with it?

It's a 2 1/2" 16ga with both Bbls at Full choke, and a clean 9.3x74R rifle barrel. No scope included, pop up rifle sight and a monte carlo cheek piece.

So from those of you who hunt with these guns over here in N. America, what have you found it suited for?
I was thinking maybe grouse and a light round of sporting clays now and then?

Thank you in advance for your replies gents!

Joined: Aug 2007
Posts: 10,736
Likes: 181
Sidelock
***
Offline
Sidelock
***

Joined: Aug 2007
Posts: 10,736
Likes: 181
If indeed it is chambered in 9,3X74R, coupled with Brenneke slugs you can use it to dispatch pretty much anything on the globe. Whose name is atop & is it a hammergun, A&D Body Action or a sidelock. Pleasure us with some images.

Kind Regards,

Raimey
rse

Joined: Jan 2008
Posts: 60
Sidelock
Offline
Sidelock

Joined: Jan 2008
Posts: 60
No brenneke in this tight barrels,maybe if you open it to 1/2 you can use Rem.slugger./ Lennart

Joined: Aug 2006
Posts: 601
Sidelock
***
Offline
Sidelock
***

Joined: Aug 2006
Posts: 601
Make sure that it's a 9.3X74R! The 9.3X72R is much more common in a drilling.

Joined: Nov 2002
Posts: 9,381
Likes: 1
Sidelock
**
Offline
Sidelock
**

Joined: Nov 2002
Posts: 9,381
Likes: 1
The 9,3x72R and 9.3x74R are very different cartridges so make sure to determine which one you're dealing with. The x72 originally being black powder type is loaded to low pressures while x74 is loaded to 300MPa. The x72 is suitable for deer at close ranges while x74 is in same class as 9.3x62 or Whelen therefore suitable for heavy game like large bear, moose, elk and bison. The 9,3x74 is much more valuable due to good selection of ammunition. It is good enough for Ruger to have chambered single shot rifles for it and Hornady to produce ammo. Good luck

Joined: May 2010
Posts: 234
Sidelock
**
Offline
Sidelock
**

Joined: May 2010
Posts: 234
bls,

The 9.3X74R is very capable of making a clean kill on the largest game in North America. The 9.3X72R, not so much as others have said. As to your tightly choked 16ga barrels, any word suggesting NOT to shoot Brenneke slugs in them is BS.

As our fellow member "Kuduae" (Axel) has taught us, any Austrian or German maker worth his salt would have regulated the left shot barrel of your drilling, loaded with a Brenneke slug, to shoot very close to the same point of aim as the rifled barrel at 50 meters for a front trigger then rear trigger "1-2", pretty much making your drilling a double rifle. If the right barrel does the same such would be pure coincidence.

I'm not sure how to get into the DoubleGun BBS archives but here is a link to another site noting the use of a Brenneke 16ga slug on a Russian boar here in the Upper Mid-West:

http://forums.nitroexpress.com/showflat.php?Cat=0&Number=243537&an=0&page=2#Post243537

Do post pictures of your Ferlach piece as I'm sure many here are anxious to see your new find.

Mark


Last edited by Buchsemann; 05/03/15 07:25 PM.
Joined: Jul 2012
Posts: 4,445
Likes: 201
Sidelock
**
Offline
Sidelock
**

Joined: Jul 2012
Posts: 4,445
Likes: 201
bls,
You can tell which 9.3 it is, pretty easily.The 72R is close to 30-30 head size, although rim dia of 30-30 is a little larger. The 74R is close to the 30-06 headsize( just a little smaller, but a 06 case will usually go in( try it head first). With a 30-30 and 30-06 case, you can figure it out.BTW Buchsemann is correct that you can use the Brenneke in any choke avaliable.The 9,3x72R is about like 38-55 to 35 Rem. A lot of deer have fallen to both of them.
Mike

Last edited by Der Ami; 05/03/15 07:34 PM.
Joined: Jun 2008
Posts: 5,522
Likes: 167
Sidelock
**
Offline
Sidelock
**

Joined: Jun 2008
Posts: 5,522
Likes: 167
My problem is why wreck a nice quail or grouse hunt by shooting a deer or elk. Then the work begins and the hunt is over.

My drilling is a Krieghoff 16x16x 8x57IR

I use her for doves, skeet/trap, and fun.

I do find the side safety a challenge for quick shooting.

The 9.3x74R is a potent round capable of taking pigs, deer and elk when close enough for accurate bullet placement.

Traditional 9.3x74R ballistics call for a 286 grain bullet at a muzzle velocity of 2360 fps with 3538 ft. lbs. of muzzle energy. That is the load for which most doubles and drillings are regulated. It puts the 9.3x74 a little above the .35 Whelen and about equal to the .375 H&H Flanged Magnum in power.
http://www.chuckhawks.com/hornady_9-3x74R.htm

Mike

Last edited by skeettx; 05/03/15 07:45 PM.

USAF RET 1971-95 [Linked Image from jpgbox.com]
Joined: May 2010
Posts: 234
Sidelock
**
Offline
Sidelock
**

Joined: May 2010
Posts: 234
bls,

Don't worry about the tightly choked 16ga tubes for upland birds. An outfit called Polywad ...

http://www.polywad.com/spredr.html

sells 16ga "Spred-R" 2 1/2" cartridges that will open your pattern up just fine.

Mark

Joined: Nov 2002
Posts: 9,381
Likes: 1
Sidelock
**
Offline
Sidelock
**

Joined: Nov 2002
Posts: 9,381
Likes: 1
Originally Posted By: Buchsemann
bls,

Don't worry about the tightly choked 16ga tubes for upland birds. An outfit called Polywad ...

http://www.polywad.com/spredr.html

sells 16ga "Spred-R" 2 1/2" cartridges that will open your pattern up just fine.

Mark


Or rolling ones own and applying old approach of no shot cup, soft shot from baggie containing mixture of slightly different shot sizes.

Page 1 of 2 1 2

Link Copied to Clipboard

doublegunshop.com home | Welcome | Sponsors & Advertisers | DoubleGun Rack | Doublegun Book Rack

Order or request info | Other Useful Information

Updated every minute of everyday!


Copyright (c) 1993 - 2024 doublegunshop.com. All rights reserved. doublegunshop.com - Bloomfield, NY 14469. USA These materials are provided by doublegunshop.com as a service to its customers and may be used for informational purposes only. doublegunshop.com assumes no responsibility for errors or omissions in these materials. THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANT-ABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. doublegunshop.com further does not warrant the accuracy or completeness of the information, text, graphics, links or other items contained within these materials. doublegunshop.com shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use of these materials. doublegunshop.com may make changes to these materials, or to the products described therein, at any time without notice. doublegunshop.com makes no commitment to update the information contained herein. This is a public un-moderated forum participate at your own risk.

Note: The posting of Copyrighted material on this forum is prohibited without prior written consent of the Copyright holder. For specifics on Copyright Law and restrictions refer to: http://www.copyright.gov/laws/ - doublegunshop.com will not monitor nor will they be held liable for copyright violations presented on the BBS which is an open and un-moderated public forum.

Powered by UBB.threads™ PHP Forum Software 7.7.5
(Release build 20201027)
Responsive Width:

PHP: 7.0.33-0+deb9u11+hw1 Page Time: 0.080s Queries: 36 (0.054s) Memory: 0.8481 MB (Peak: 1.8987 MB) Data Comp: Off Server Time: 2024-03-28 17:34:41 UTC
Valid HTML 5 and Valid CSS