Any idea where I can get new springs for the 28ga 11-48?
Too bad for me I have a pile of Fiocchi factory shells and Challenger too, loaded in Canada using Fiocchi hulls. I.m stopping at Ballistic Products on the way back from Flatwater so I'll see if they have US 28ga hulls and buy a lever collet type sizer to crunch the higher brass on the Remington and Winchester hulls, without one of those high brass hulls are a pain in the Mec Jr. they jam in the sizer. I have one in 12 ga and it's a must, Federal paper hulls fired in a gun with sloppy chambers swell out a bit at the head. Thank you for the good advice,
Mike
