Jim, by not working do you mean that you cannot move the safe to on or off, because with the Hunter One-Trigger the safety is a manual safety, it will not go to safe when the gun is opened.
Also on the 3 position safety which it wouldn't have with the Hunter One-Trigger, in the rear postion when the gun is broken the safety will not return to safe, only in the most forward position will it return to safe.
The only thing that you could have done wrong was to put the safety link in the wrong spot in the safety slide.
Unfortuatley you have to take it apart again. This time when you do it push the safety forward and then place the trigger assembly in and watch that the bar in the safety link catches in the notch of the safety slide. Then release the top lever by pushing down on the trip and try moving the safety and try the trigger. You will have to move the top lever to the open position again, it will be harder to do since there is nothing for the spring to hold. Also before you move the top lever you will see that the top lever shaft is a lot closer to the hole for alignment, but you won't be able to put the top trigger plate screw in because the lever will be hiding the hole.
David
jdavidw1@comcast.net
Didn't see your post that you had it fixed as I was writing this one. Glad you got it.
Last edited by JDW; 03/16/08 03:23 PM.
