Chuck, Have you done a Butt Transplant without the Draw-Bolt???The 20 O/U Pre 1964 Beretta that is Pictured in OUR book(onyour Workbench)only had the'Hand-Pin'at the rear of the trigger and a wood screw under the top lever.Oh boy..read TRIGGER-PLATE)..I have in the W/S a Lefever'Cgrade' 99% case Colouring on Action/Side-Plates.BUTSomebody Miss-Read the artical WE wrote,put way too much angle on the cut-off,the drop at heel is 6 1/2" Then ran 2 3" wood-screws in from the T/Guard channel. Then used a Industrial Strength epoxy to finish of the job! Question, Do you want a Challenging Job'....Always something New at the Workshop Door!!.....Salopian, Do you know the Chap that also does the "Art-Work on Stocks who is in Reigate? Redhill? I saw a French"Purdey look-alike' that I think came from his w/shop It was"Bond Street Art Gallery Quality"! Just like the [photos on this thread! I had to "Set a 16b Francotte some time ago, I was"Perplexed"sp) when the stock finish with all the luverly marble figure dripped off into a puddle into the oil-tray! Always an Adventure with Old Guns!!!!CC
