Fox,
Go to Brownells and order bit#'s 340-1,2,3 &4. For instance, a 340-1 is a blade .340" wide by 0.010" thick. Buy all 4 and one of those will fit perfectly or be close enough to alter easily. Those will handle the underlever screw and main floorplate screw.
Try to determine the width of the slot in your triggerguard screw....most likely a 240 or 270 will do. Then buy the 4 thicknesses (240-1, etc.)The rear tang screw under the triggerguard will be served by one of those.
If you haven't disassembeled a Fox before, I suggest you read "disassembly instructions" on the homepage of the Fox site...
http://www.foxcollectors.combest, Mike
