Continue to wire the upper and lower ribs as pictured. The lower rib will require thin 1/8" stock holdowns so you can work around them. I used aluminum. Find something that fits your setup/gun. You need about 3 hands to do the wiring to hold everything. I also made some little doublers out of steel roofing flashing (.010 thick) because the barrels have some really thin areas I was concerned that the wiring may dent the barrels when tightened. Don't forget to turn the ends of the wire in like a pigtail so you don't cut yourself around them.










Last edited by Chuck H; 01/07/08 03:30 AM.