Stripped, cleaned and reassembled with light lube over entirety and a grease where appropriate.

Barrel proofs are 12ga and the both bores are .730"
Bad news is some notable pitting on the exterior of both barrels under forend.
I could measure barrel wall thickness and strike the tubes, but there are a couple pits on each that are clearly too deep to remove and leave sufficient wall thickness.

Mechanically sound(though worn), tight on the face, no cracks in the buttstock.
Choices would be to sell it as a sleever, or it would make an interesting cutaway.

[Linked Image from i.postimg.cc]

[Linked Image from i.postimg.cc]

[Linked Image from i.postimg.cc]

[Linked Image from i.postimg.cc]


Mike