doublegunshop.com - home Forums General Discussion Classic & Custom Single Barreled Sporting Rifles @ doublegunshop.com WTB 400 Whelen brass

Agreed there are any number of ways easier than engraving. I have access to a cnc laser engraver, a dot peen machine, etc but I’m also working on learning to engrave and this would be a good way to practice lettering. I would be the customer so if the first few look bad I’m the only one who has to look at them. Or I can throw them away.

I got 100 pieces of proper headstamped brass from quality cartridge. I wasn’t aware of star line basic when I ordered or I probably wouldn’t have ordered it.

I found this, sheer luck. www.doublegunshop.com/forums/ubbthreads.php?ubb=showflat&Number=332786

prairie ghost'
Your link didn't come up.
When trying to make cases with the correct headstamp, if you take the original headstamp off and deepen the primer pocket (with primer pocket uniformer) before establishing the headspace by fireforming, it shouldn't cause a problem. For belted cartridges, you should set the dies up to headspace on the shoulder. In my experience, removing about .015" will take the original headstamp off. Removing less than this may be enough to make the original headstamp inconspicuous.
Mike

Sorry about the link. It was about headstamps and others problems/limited solutions. I have 3 that I would like to be able to mark for posterity's sake including 400 whelen. Seems easier than a bunch of notes. Will solider on.