Thank you for all the recommendations! I will check out some of those sources. As a tip to the guys that use these tools, I did away with the stupid pin(nail) long ago. The hole in the handle and the cutter is hit and miss as to perfect line up and the cutter frequently wobbles in the handle. I just use super glue. If you want to take the cutter out just heat it with a propane torch for 2 seconds. The glue melts and you can remove it, clean it and replace it. If the Ullman cutters fit in the dem bart slot that would be great since I have a number of handles.
Keith, I have no doubt I'm on some list. I been doing this gun stuff for a long time and supporting politically incorrect politicians nearly as long. That link you posted is something I'll keep just in case this jackass administration doesn't get us blown up or in the nuclear winter. Since my wife is from Belarus she knows Russian and she could deal with them for me. But, as you said they need to lift sanctions. You know, those sanctions that where suppose to hurt Russia, and did for about one week. They hurt the USA and Europe more than Russia. The stamp is very fitting!
BrentD, never heard of Steve Earle's checkering tools. I will definitely want to check them out.
It's a shame, you get use to using one system of tools and then have to change everything this late in the game. But I'm not against quality or improvement so I'll check them out
