The difference in crush section length will change pressures slightly.
The crimp quality depends on the hull volume.
I’ve loaded them with either wad, but prefer a tad more powder just so the stuff burns. Since I’m paying for it, I’d rather it burn. Titewad is very clean when used at pressures above 8500 psi.
I’ve burned a lot of Titewad. It does not play well with the Fiocchi 616, it likes a hotter primer.
I have been using 14.8 TiteWad in 12 ga.Gun Clubs with 3/4 oz. payload with Claybuster CB0175-12 wads, Cheddite 209 primer, 7200 psi and 1150 fps. These loads burn very nice and no residue in barrels. Same load in a Winchester AA HS. TiteWad is the one of the hottest burning powder.
