I've never done any business w/ SKB but I would happily spend $300
in today's market for a single plane stock bending job assuming it was quality work that includes bending the trigger guard & retiming the trigger guard tang screws as required & in a reasonable ie. <6 months turnaround.
No good gunsmith is going to guarantee results on bending a stock but I would expect good guidance on what is possible & what is not.
Are you sure they always have to bend the trigger guard? With heat, such as a torch? Thats not what Ive observed, at any rate. It does not appear all that complex, otherwise BrentD wouldnt be able to do it., like he says he can.
