Joe,
I had a delay caused by a hand injury that resulted in an infection. I had just doubled the size of my shop,built several more work benches and fixtures, and then I lost the use of my hand. It's healing now, so once the inflamation is gone I'll begin the cycle. I don't want to take the chance on dropping a set and damaging it.
One good thing is that I've been researching less invasive methods of tube prep, and I'm planning on using electrolysis to remove the old coating on your set, so I should be able to avoid abrasives and chemicals when prepping your tubes. All with the intent on maintaining existing tube thickness.
Regards
Ken
Last edited by Ken61; 10/14/16 10:40 AM.
