It's easy to pull bullets & brass is hard to find. If you don't have a bullet puller, Put the cartridge in your loading press no die. Run the case up so the bullet is exposed. Grab it with a pair of slip joint pliers, ones that have the round cut out in the jaws.
Lower the ram, pliers stop on the presses top, bullet pulls right out. Dump the powder re-size the case with the primer punch removed then load as normal.
Don't try to punch out the hot primer, load using it as seated.
Opps you don't reload, then give them to somebody who does.
Boats
Last edited by Boats; 05/24/16 02:06 PM.
