Thanks, Boats.
One issue I see with the disc sander I bought, as opposed to a big belt sander, with a belt sander you could run an 80 grit to take it down most of the way, then easily change belts to a finer grit for a bit smoother finish before hand finishing. I'm sure you could start out with a finer disc, to begin with, and it would just take longer to get the pad ground down near the line. Harder to change the sanding discs that are held in place by adhesive backing. I don't see at as a big deal, though, since I will be finishing them up with a sanding block anyway.
SRH
Last edited by Stan; 05/11/16 07:08 AM.
