Well, this is an interesting thread! I have a very good friend that is going to be producing cutters for the Brownell handles. The initial cutters will be single line 75deg, 22LPI, and 24LPI, that's because I need those the most (selfish I know). He said that any of the common spacer sizes would be easy but he just hasn't done them yet.
The spacers are made from A2 steel on a CNC machine and finished using wire EDM and hardened. He also added a nice side benefit in that the cutters are marked on the side with the LPI. That's for us old guys who can't remember. These cutters WILL NOT be cheap - $21 a piece. That is a lot of money for a cutter however since they are very hard I get a least twice the wear from them. The cutters start sharp with no garbage that has to be removed before they are used for the first time and they stay sharp.
I'm not sure if I can mention the supplier or not but I' will say that he manufactures high end single shot rifle actions along with other firearm related products.
Doug
Last edited by Doug Mann; 12/20/15 01:29 PM.
