make those small cuts while inletting smal round items like trigger guards and forend latches? I need to know what type of tool that I can make very fine vertical cuts acroos the grain thet have about a 3/16" radius.
Thus far, I have usd the Dremel tool and I have made some scrapers that will work but are very slow in cutting the end grain.
I am attempting to put the finishing touches on the forend latch of an O/U and only have about .003" to go on the curved inletting. This is not the time to have a large gap appear in my otherwise very good job of inletting!
TIA,
Franchi
