I have been shooting my 14ga Patrick Mullin quite a bit lately with modified Greener police 14ga brass. In preparation for the upcoming season I thought I'd clean my brass up starting with a run through the vibe. Long story short, case mouths became dented and enlarged enough (.010 larger than an unfired case) to drag going in and out of the chamber.
What do you do about an oversize brass shotshell? My initial thought is to make a plate with a hole to push the shells through in a "resizing" fashion. Also thought about trying to just shoot them to see if they will straighten out enough to not drag.
Suggestions?
Thanks,
Bryndon
