Handy drill guide I use on longrifle stocks which are very awkward because of length to get all positioned with a vise and drill press. The screw on the right has been center drilled to let a 1/8" bit pass through. I have another for 1/16" drills useful for longrifle pins. Greatly expedited accuracy and production with all the holes required on longrifles. The gap between jaws is 3". I normally drill half way from each side, swapping the guide around takes just seconds. Use it with my cordless drill or old hand drill. .

Last edited by Jerry V Lape; 04/25/07 08:12 PM.