I just can not pass up another project. This is a 12ga, 27" full and full, side plated-boxlock, ejector with a lot going for it. The project part is a broken stock which has been repaired once it looks like. I think I can repair is better than the last attempt and make it stronger than new. The checkering has been buggered up but that is just minor problem next to the fractured stock. If it is not split internal I am going to glue it up and inlet a fillet to repair the cracked wrist. If it is split or cracked at the head I am thinking about a butt transplant onto a new head-wrist inlet-ted short stock. Need to take it apart and see how bad it is.

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1144_zps1bd5f6d8.jpg

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1115_zpsd11df48b.jpg

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1116_zpsfff472db.jpg

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1117_zps6edb6a70.jpg

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1141_zpsf343f968.jpg

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1120_zps272b2dda.jpg

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1122_zpsa1e7cb11.jpg?t=1398141100

http://i1359.photobucket.com/albums/q787/jfoh5914/Crackp/IMG_1126_zps2f892868.jpg

Last edited by KY Jon; 04/22/14 12:01 AM.