Sooner or later we all run across a screw that will not loosen, frozen in place.

If you have been reading the gun boards for any length of time there are hundreds of ways to get that screw out. Heat, drill it out, penetrating oil, hitting the screwdriver with a hammer and list is endless.

The best way I know is to use the mill or drill press, put a Brownell bit ground to fit the slot into the chuck. Lower the quill or raise the table until the bit is solid straight into the bottom of the screw and lock everything down. Use you hand (make sure the equipment is unplugged before you start)and just turn the chuck. The screw will come out or the head will come off, then your lined up to drill it out if need be.

MP Sadly Deceased as of 2/17/2014