OK I finally got around to getting the engineering done on new Parker roll joints. I am having them cut by EDM in 3 sizes over what an original one was. We made them .003", .005" and .007" over size. They will be fit soft, then sent out for color case hardening. Of all the methods I use to put a gun back on face, this one takes the most engineering and investment of capital, the cost to the consumer will reflect that. This is not an inexpensive process, but it will allow you to put that old Parker back on face in a way that is completely undetectable....
just the way the it was done it the Parker factory.
Steve

Firearms imports, consignments


[Linked Image from i.imgur.com]