doublegunshop.com - home Forums General Discussion German & Austrian Sporting Guns @ doublegunshop.com Help with frankonia scope on a drilling

Mike V,
Gunter is correct. Be advised that depending on if the screws are threaded into the top part or bottom part of the rear ring,the screw may either "push" or "pull" the scope. This can be confusing.There should be witness marks on the back side.By watching the marks while turning the screw, you can see which way it works.If there are no marks, they are easy to make. If you don't want to mark the mount,you can mark it on two pieces of tape.Also take the scope off to adjust it, then put it back on (I don't know why-that's just how Walter did it).
Mike