the (old)single turret scopes only have elevation setting (the turret)
these scopes are fitted to the rifle by claw mounts.
on the rear mount (foot) you should have a large screw-head on either side - here you set windage by loosening one screw and turn in the other until you have center-line.
Then tighten up and try on a target.
if necessary, adjust again.
Cumbersome but will hold center once its adjusted.
Best regards from England
Günter
NRA Life 1974
an old Zeiss Jena scope (single turret) which I use on a HW97K air rifle with
EAW (Ernst Apel) swing off mounts - yours might look different but the principle is the same
