bghntr416 Thank you for the tip on Woodleigh .318 Bullets I found them at Miday I had no idea that Woodleigh made anything other than Large Calibers.
Jani thank you for your report on the 8x57 Remington Bullets. RWS doesnt seem to have much of a Distributer network in the US I have not found a source for the .318 bullets.
Der Ami What do you use to swage the bullets with? In the past I have swaged or resized Cast bullets but never Jacketed Bullets.
Kutter Very good information, thanks for the tip on the dies and the lower velocities. If I could get 2200 FPS that will be A-OK for my purposes with the open sights this will be a 150 yard or under shooter. And I think that would be in the 32 Winchester Special Envelope?
PA24 Thank you for the valuable information about the Bullet Molds, following someone elses experiences with what Mould/Bullets worked for them helps tremendously! I am set up for bullet casting and did a little of it 30 years ago mostly for handguns, but I did fool around with .30 Carbine and 30-06 Cast Bullets with mixed results. I will hold off on the Cast Bullets for now. My next Rifle to load for is a 9x57 Mauser Sporter and that will definitely be with Cast Bullets.
NTaxiarchis thanks for the tip on the Buffalo Bore Bullets I am going to give them a try also.
I have ordered some Redding 8x57 dies.
Last edited by postoak; 02/02/13 11:12 AM.
