Ok, here goes. Restocking your project will run about $5000 (with nice wood). The welding will cost you about $100. I suggest you do not have someone not familiar with guns do the welding. You will need to have the back hand pin hole redone as well to make it correct. The choke tubes from Briley have been running about $450 with shipping (unless they raised their prices for 2013.) Charles Lee is one of the best for pick up engraving being an Ariticled Purdey trained engraver....$750-$2000 you will have to talk to him.
As for fixing the gunstock....refinish, repair, and rechecker will cost about $1200. I have looked at all of the pictures and have guestimated there are about 45 hours of work that needs to be done in order to make it right. The stock has seen some rough times. It can be done.
Last edited by DES/TSD; 01/20/13 12:45 PM.
