All it takes is money, most anything is possible......
SKB
Why couldnt a machinist take that Boss, cut the barrels off at the end of the chambers and then use the stub as a pattern to create an identical monobloc in modern steel (similar to how stocks are duplicated). Next take the remaining sawed-off barrels and duplicate them in modern steel, but add a sleeve to the end of each barrel to reattach it to the monobloc, then the barrels could be regulated, re-ribbed with the original ribs, rebrowned, and the gun put back into service with barrels made from modern alloy steel. Im not a machinist, is what Im suggesting prohibitively expensive, or just a dumb idea.
Steve
George I know you want to redo them in damascus and I don't blame you, I was just think this could be a solution if the damascus chamber walls were going too thin to sleeve on damascus tubes.
