Hi, been reading with interest as I'm currently working on a nice set of damascus barrels , I was concerned about some pitting and looked into sleeving and possibly re barreling. I contacted peter Dyson(uk) about the damascus tubes on their website, I was told they are blanks so would need boring etc and striking down externally , would this extra wall thickness on the original blank enable them to be 'made' to fit most if not all guns , given that the centres and measurements mentioned earlier on this thread could be re produced ?
I have no intention of doing any barrel work other than browning , polishing and a bit of tightening up where necessary as I simply don't know enough about it and would rather leave it to the trained experts, but in cases like this, and I realise it won't be cheap, would this be the most straightforward way to go ?
