Well, getting closer to going "boom" - at least to see if it will.

Trimmed up the action a bit, rounded some corners, all the workings inside are done.


Been working on the stock, here are both sides, this is a two piece laminated walnut. Will have toe and heel plates and checkered butt. Comb is too high, but waiting on the sights before hacking off too much.
Right side (duh)

Nuther side


Next to make a main spring and the forend wood.
Tang sight is on the way.


Dumb, but learning...Prof Em, BSc(ME), CAE (FYI)