Ok Steven, I took proper chamber measurements using an inside micrometer and came up with these numbers
At the mouth of the chamber the measurement is .814" then it tapers down smoothly to the start of the forcing cone at which point the diameter is .801"...a taper of .013" over an exact 2.875" in length
Like I said they look pretty original.
Frank....I sent you a pm
Doug.... I'll send you this one and you send me the Lefever, so I can check it out...sounds fair to me
Bill we're kind of short on time this month.....might not happen
but I'll have a better idea next week.
Mike here's a shot of the bottom...no reinforcing wedge on this one
CJ
