doublegunshop.com - home Forums General Discussion DoubleGun BBS @ doublegunshop.com Remington 1894 issue

October
S	M	T	W	T	F	S
			1	2	3	4
5	6	7	8	9	10	11
12	13	14	15	16	17	18
19	20	21	22	23	24	25
26	27	28	29	30	31

Who's Online Now

2 members (SXS 40, Tim Cartmell), 383 guests, and 4 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums10

Topics39,515

Posts562,243

Members14,590

Most Online9,918
Jul 28th, 2025

Print Thread

Page 2 of 2

Re: Remington 1894 issue WoollyBugger #222179 03/18/11 07:00 PM
Joined: Jan 2002 Posts: 1,439 Likes: 4 The Ozark Plateau Bob Blair Sidelock
Bob Blair Sidelock Joined: Jan 2002 Posts: 1,439 Likes: 4 The Ozark Plateau	Can't remember which gun it was or which cartridges but I had this problem a few years ago and it was totally ammunition dependent. It was like the firing pins got stuck in the soft primer brass.

Re: Remington 1894 issue WoollyBugger #222196 03/18/11 09:34 PM
Joined: Feb 2011 Posts: 1,405 Rochester, NY B. Dudley Sidelock
B. Dudley Sidelock Joined: Feb 2011 Posts: 1,405 Rochester, NY	I was thinking of posing the question of ammo, but he never mentioned that the gun was new, so I thought he was just shooting the same stuff he would have normally shot without any trouble. The changed variable seemed to be the replaced firing pin. B.Dudley

Re: Remington 1894 issue WoollyBugger #222215 03/19/11 01:17 AM
ben-t Unregistered
ben-t Unregistered	Put in some snap caps, drop the hammers, then open the gun while holding it under a bright lamp to see when your pins start to retract. If they start back immediately it isn't timing. Try them with a pair of fired hulls and see what happens. Deep pin holes and drag marks?

Re: Remington 1894 issue WoollyBugger #222227 03/19/11 07:08 AM
Joined: Feb 2011 Posts: 1,405 Rochester, NY B. Dudley Sidelock
B. Dudley Sidelock Joined: Feb 2011 Posts: 1,405 Rochester, NY	Timing really should not be an issue, since a lot of Doubles do not start cocking until the breech is open at least a littel bit, whereas your resistance of the pins in the primers is giving you a problem right when the breech is tried to be opened. B.Dudley

Page 2 of 2

Link Copied to Clipboard

Updated every minute of everyday!

Copyright (c) 1993 - 2024 doublegunshop.com. All rights reserved. doublegunshop.com - Bloomfield, NY 14469. USA These materials are provided by doublegunshop.com as a service to its customers and may be used for informational purposes only. doublegunshop.com assumes no responsibility for errors or omissions in these materials. THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANT-ABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. doublegunshop.com further does not warrant the accuracy or completeness of the information, text, graphics, links or other items contained within these materials. doublegunshop.com shall not be liable for any special, indirect, incidental, or consequential damages, including without limitation, lost revenues or lost profits, which may result from the use of these materials. doublegunshop.com may make changes to these materials, or to the products described therein, at any time without notice. doublegunshop.com makes no commitment to update the information contained herein. This is a public un-moderated forum participate at your own risk.

Note: The posting of Copyrighted material on this forum is prohibited without prior written consent of the Copyright holder. For specifics on Copyright Law and restrictions refer to: http://www.copyright.gov/laws/ - doublegunshop.com will not monitor nor will they be held liable for copyright violations presented on the BBS which is an open and un-moderated public forum.

Responsive Width:

PHP: 7.0.33-0+deb9u11+hw1 Page Time: 0.086s Queries: 22 (0.065s) Memory: 0.8069 MB (Peak: 1.9018 MB) Data Comp: Off Server Time: 2025-10-15 16:06:26 UTC
Valid HTML 5 and Valid CSS