I know that some on this board have an extensive knowledge of the various adhesives on the market-maybe someone can help. My problem is, I was tinkering with my old Pacific 150 DL reloader last night in about 0 degree temperature in my unheated garage. I know, what the heck was he thinking! I wasn't reloading, just tinkering.
I was trying to adjust the position of the lever that the wad spreader/guide fits into and it snapped off on the back where the set screw tightens down on the main beam.
I have some Loctite Super Glue 2 All Plastics, that I used to attempt the repair, without success! I cleaned it up and then tried some all purpose epoxy, again without success! The material is some sort of hard plastic circa mid-60's.
Since the machine has been out of production for many years, I imagine parts would be almost non-existent.
Any and all advise on what could be used would be appreciated.
Thanks!
Cameron
