Thanks Jim, BTW it's just Khanh. I will take all suggestions into consideration. I have cleaned the chambers, I will remove the ejectors and clean. I confident that the gun is tight and not off face. I will not have time to take the guns out again for a few weeks (family and work duties). I don't buy guns new so the majority of my guns have been used so this may be due to lack of use of the number two gun. I am not confident enough to do any work on the guns myself so they will go off to Jim Greenwood to look at.
So Khanh is your first name, not Mr. Khanh. Welcome to the board, Khanh. As you say you're not confident to do any work on the gun, yourself, I would not recommend taking the ejectors apart, either. If your gun actually has EXTRACTORS, rather than ejectors, the extractor is pretty simple. An extractor is one piece and simply slides back and forth, held in place by a small screw. It pulls or extracts the shells part way out of the chambers, regardless whether they were fired. Ejectors are two pieces, fairly complicated and usually eject only the fired shell, out of the gun and into the air. The terms are not interchangeable.
