OK, I've been working like a fool on knives for Sporting Classics magazine. When time permits, I sneak in an hour or two on this one. I have the action cocking and ejectors working.
I had to make a new set of hammers, and during programing, I mirrored the drawing not realizing I would need to make new spring struts to fit the new hammers. They needed a little tweaking anyway, so a new set was machined with improvements.
Since the action is damascus, so the stock furniture will be as well. Here is the grip cap...
and a quick etch on the action reveals a little of the damascus pattern....
I have the skeleton butt plate ready to install and will get a couple of shots when I am able to do that. The action needs a little tuning, firing pins and then it is time to chamber it.
