doublegunshop.com - home Forums General Discussion DoubleGun BBS @ doublegunshop.com 2" load data needed

I have some once fired 2" paper hulls from RST that appear to be Cheddites that I wish to reload. Got a short wad from Ballistic Products (12 SSW) that looks like a Gualandi made wad but the included data only shows two loads with Fiocchi hulls and primers.
Found three recipes in the 2007 Hodgdon manual for Remington and Winchester hulls.
Any one out there with data for RST/Cheddite paper hulls?

Jeff

Ballistic Products lists some 2" loads in one of their pamphlets.

I believe Hodgdon's website also lists some 2" loads.

I have some data using Red Dot powder and felt wads. I use Vihtavouri 310 and Vectan AS powders as a rule if they are available to you. If so let me know and I will describe the loads. All I make use card and felt wadding. Lagopus.....

Lagopus,

Red dot data would help. Don't have the V- powder.
you can post here or email me
fullandfuller@netscape.net

Jeff

Jeff, the information I have got for cases such as yours; ones that are not compression formed, are for use with either the Win 209 or CCI 109 primer and 7/8th. ounce of shot, platic obturator wad and card and felt to thickness (lists 7/16" fibre and 1/16" card undershot wad - closed with a roll turnover). Red Dot 19.5 grains or Trap 100 22 grains. These were all proof teated and found suitable for 2" chamber guns. Other straight wall cases trimmed down to 2" can of course be used. Good luck with them. Lagopus.....

Lagopus,

Thanks for the load data. Do you have any velocity and pressure numbers?

Jeff

No, sorry, nothing more other than the loads are safe in 2" chambered guns as tested by the Birmingham Proof House. Lagopus.....