Stan my Krieghoff argument counters your argument about the Berreta barrels being straightened in a press. You argued that since the Beretta mechanic was straightening them they had to be straight in the final barrel assembly. The ability to adjust the Krieghoff POI by bending the straight barrels means that the tubes in side by side barrels can be curved when they are assembled, even though the Beretta mechanic previously straightened them, just as the straightened Krieghoff lower barrel can be curved, either up and down, long after it left the factory.
Prove that they don't curve the tubes in a side by side when they assemble them into a barrel set.
I point out again the math I did in the thread on the Parker BBS that I linked to.
And the Skeets smith said that some barrels were curved.
Last edited by AmarilloMike; 05/09/14 09:32 PM.
