doublegunshop.com - home Forums General Discussion DoubleGun BBS @ doublegunshop.com Machine new Browning BSS extractors/ejectors?

I've got a Browning BSS shotgun in 20 gauge with two broken extractor/ejectors. These parts are unavailable. (if anyone knows where they can be located, please let me know!) I've had a local gunsmith send them off to a micro welder for repair. The first two efforts were unsuccessful, the extractors broke on the first dry-fire and attepted ejection. The third time they passed the dry fire test, but I am scared to fire them for real.......afraid they will break again and I may loose a part in the field. This is obviously no good. Can I have these parts machined from scratch and what would be the cost? They are small, frail, and rather complex to start with in my opinion. Any input or suggestions would be greatly appreciated.

Thank you.
RRB

Can you file and fit the ejectors from oversized ejector blanks? You have the originals to mic in all directions, so that makes it alot easier. Blanks are not to difficult to find, so unless you can't find an oversize pair or the one you need, it would probably be alot cheaper than milling them from scratch

Did you try Western Gun Parts? http://www.westerngunparts.com/

They acquired all the Browning BSS parts.
I've bought many little parts from them for my various BSS guns. Recently, I bought some trigger parts.

You might contact:
Louis Rotelli
203-948-4001
mustangws1@aol.com
He's made some Parker and LC parts for guys in need.