I enjoyed my RBL but the stock drop was too low and the through bolt precluded bending the stock enough to make it fit.
It seems more than a little odd that two sets of barrels would be identically off in POI - though I suppose in a production gun like this a batch of barrels could have come through the line with the same defect.
If the through bolt were accidentally bent out of line before the stock was installed, is it possible that when the stock was intalled and through bolt was tightened, it pulled the stock out of alignment with the action and the barrels? My son'e Benelli Montefeltro has shims that are used on the through bolt to change stock drop and cast.
Last edited by Doverham; 08/31/12 05:51 PM.
